Electrostatic Purification 223 CFM Wall Mounted ERV System

130W wall mounted fresh air ventilation system prevention of coronavirus PM2.5 purification energy saving

 

► CHARACTERISTIC

★ Super purification

Using electrostatic purification technology, the electrostatic dust collector generates 10000 volts high voltage, which makes the dust in the air carry electric charge. The air passing through the electrostatic dust collector is absorbed by the positive and negative plates. Through the 10000 volt negative voltage, the bacterial cell tissue is destroyed and the bacteria are completely killed. The purification efficiency of PM2.5 is as high as 99.9%

★ High efficiency and energy saving

The brushless DC motor can save more than 40% energy than AC motor, the fresh air and exhaust air share the same fan, only 0.5 kwh power is needed for 24-hour operation

 

★ Automatic ventilation

When the indoor air concentration is lower than the set value, the control system will start the automatic ventilation mode. When the temperature difference between indoor and outdoor is lower than the set value, the system will automatically open the bypass valve mode.

 

★ Wireless monitoring

 Transfer the operation status to the mobile phone through Wifi directly, so that the operation of the system can be mastered anytime and anywhere.

 

★ Remote operation

Master the actual operation of the system through Wifi, but also through the mobile phone to achieve remote operation.

 

★ Intelligent mute

The unique structure design of the fresh air fan, adopts the DC brushless motor,  design the large diameter wind wheel specially, the low speed, the machine does not produce any noise during operation.

 

★ Convenient maintenance

The fan runs at low speed and has low failure rate. Ceiling and wall mounted fresh air ventilaiton are both have one fan and two wind wheels, which is 50% less than other brand products.

 

★ Low carbon environmental protection

The electrostatic dust box can be repeatedly cleaned (the design service life of the dust box is 10 years), the primary efficiency and high efficiency filters can be replaced with little money, the surrounding aluminum frame can be reused, saving money and environmental protection.

 

► SPECIFICATION

 

NAME	Wall mounted fresh air ventilation
FRESH AIR VOLUME	380m3/h
PURIFYING RATE	PM2.5-99.9%
POWER	220V/50HZ
MAX. POWER	130 W
WEIGHT	70 Kg
APPLICABLE AREA	80-100 m2
AIR SUPPLY MODE	Direct air supply

 

► SIZE

 

► ADVANTAGE

★ PM2.5 removal effect diagram

solubility

 

minute            10      20      30       40      50       60     minute         10       20      30       40       50       60

 

When the machine is started for 1 hour, PM2.5 decreases by about 25 ug / m³, which is the high quality air standard,

formaldehyde drops to about 0.3 mg / m³

 

★ Efficient filtration

Primary filter

Large filtration area and large dust capacity

The spreading area of primary filter is about 3 m³,It can filter large particles,

block mosquitoes, hair, etc.

Characteristic:

The primary filter is made of fiber cotton,It has the characteristics of large filtering area, large dust capacity, low wind speed and low resistance. The service life of the follow-up filter screen depends on this layer.

 

 

Medium efficiency filter

More than 97% of PM2.5 was filtered at one time

 

High efficiency filter

H13 medical grade filter screen, single filtration 99.95% PM2.5

Characteristic:

PTFE composite filter element is adopted,compared with the traditional glass fiber, PTFE filter paper will not emit chemical gas

The spreading area of primary filter is about 30 m^3,depending on the service environment, it is generally replaced within 1-2 years.